Printed from www.nzmeccano.com
Login status: You have not yet entered your user name and password. You cannot upload photographs until you do.
Item 5 of 7
Bearing in a slotted hole
The rear 12.5" angle girder had its round and slotted holes swapped round, which meant a round hole bearing was required for the strike wheel drive shaft. A stack of 1.5" narrow strips are bolted inside the flange of the angle girder.
Image by Richard Payn, viewed 1027 times.
Size: 550.17kb (2000x2666 pixels) 
Log in to the gallery
If you have any interesting information or comments about this page, please add them here: