Home | Links | Contact |

Printed from www.nzmeccano.com

Top Home Bottom
Login status:  You have not yet entered your user name and password. You cannot upload photographs until you do.
Meccano GalleryUser galleriesMike DennisDoctor Cheapo's Meccanomics & DIY-Cano Doc Cheapo's Heretics workshop - etc
Item 1 of 14
Up Prev Next

Second op Hand tooling  

Small Threaded Parts made in a lathe such as Handrail parts may need hand finishing to save wrecking the part. This tool safely holds the part in the vice. -- thereis very little tapre on the back face of a die. - So reverse the die in the holder the hand thread the part up to the face, spin it back and Bingo - Job done safely - I have other holders too in the workshop - so hence No 1 `  

Second op Hand tooling
Image by Mike dennis, viewed 208 times.
Size: 38.05kb (700x599 pixels)

Log in to the gallery

Enter your user name and password to log in

Remember me

If you click on the box marked 'remember me next time', you will not have to log in again on this computer for three months.

If you don't have a user name yet, please click here

If you have any interesting information or comments about this page, please add them here:


Your name:
Your message:
Security check: (Please type in the text to prove you're a person!)
 

On this page...

Recent stuff going on: